4 修訂歷史記錄

Changes from E Revision (January 2015) to F Revision

• 將溫度范圍從 0°C 到 70ºC 更改為 –40°C 到 85ºC。Go
• Changed T_A To: –40°C MIN and 85°C MAX From: 0°C MIN and 70°C MAX in the Recommended Operating Conditions tableGo
• Changed the P_D values From: MIN = 15.5, MAX = 21.6 To: MIN = 2.8, MAX = 4.4 in the Dissipation Ratings tableGo

Changes from D Revision (December 2015) to E Revision

• Changed "over the full industrial temperature range of –40°C to 70°C" To: "over the commercial temperature range of 0°C to 70°C" in the Overview sectionGo

Changes from C Revision (July 2015) to D Revision

• Changed "full industrial temperature range of –40°C to 85°C" To: "full industrial temperature range of 0°C to 70°C" in the Overview sectionGo

Changes from B Revision (November 2013) to C Revision

• Added 引腳配置和功能 部分、ESD 額定值 表、特性 說明 部分、器件功能模式、應用和實施 部分、電源相關建議 部分、布局 部分、器件和文檔支持 部分以及機械、封裝和可訂購信息 部分Go
• 已刪除訂購信息表Go

Changes from A Revision (February 2012 ) to B Revision

• Added 額外特性：雙向“復用/解復用” ("MUX/de-MUX") 差動開關Go
• 已添加此器件支持 XAUI 和 SGMII 的內容Go
• Changed 溫度范圍“–40°C 至 85ºC”至“0°C 至 70ºC”并刪除了說明部分中的“工業(yè)” 部分添加了 EDI 固件功能列表.Go
• Changed pin description of NC From: Electrically not connected. To: Electrically not connected. May connect to VDD or GND, or leave unconnectedGo
• Added the Application Information sectionGo

Changes from * Revision (January 2012 ) to A Revision

• Changed 將差分 BW 特性著要點由“7.5GHZ”改為“8GHz”Go
• Changed 將動態(tài)特性子著重號從 “隔離” 改為 “斷開隔離”Go
• Changed 將動態(tài)特性子著重號回波損耗從 "-9dB" 改為 "-11dB"Go
• Deleted 動態(tài)特性子著重號 "最大內部對（位-位）偏斜"Go
• Changed ESD, Human body model, MAX voltage from "±2000" to "±4,000" in Absolute Maximum Ratings tableGo
• Changed I_LK spec (Diff I/O pins) MAX value from "4 µA" to "130 µA" and added [Ports B and C] and [Port A] to Conditions statements.Go
• Changed t_PD spec MAX delay from "50" ps to "85" ps in Device Parameters tableGo
• Changed SEL-to-switch T_on and T_off spec TYP values from "175" ns to "70" ns; in the Device Parameters tableGo
• Changed T_{SKEW_Inter} and T_{SKEW_Intra} spec MAX values from "5 ps" and "4 ps" respectively, to "20 ps" and "8 ps" respectively, in Electrical Characteristics table.Go
• Changed R_L spec TYP value from "–25" and "–9" dB to "–28" and "–11" dB for f=0.3 MHz and f=4000 MHz, respectively, in Electrical Characteristics table. Go
• Changed O_IRR spec TYP value from "–70" to "–75" dB for f=0.3 MHz, in Electrical Characteristics table. Go
• Changed BW spec TYP value from "7.5" GHz to "8" GHz in Electrical Characteristics table.Go
• Changed graphic image for Figure 3.Go
• Changed graphic image for Figure 4Go